Livraison gratuite à partir de 5000 EUR! Notre entrepôt est prêt à stocker vos commandes jusqu'à ce que le montant requis soit atteint
Isolating relay with window contact, 1 NO contact 10A
Prix (HT):
41,01 €
Ce prix est valable jusqu’au 2024-12-31
Prix par m:
41,01 €
EAN: 4010312205495
MPN: 61100631
Notre entrepôt:
Non
Stock fournisseur:
Non
Par colis:
1
Par boîte:
1
Par palette:
N/A
Données techniques
| État de l’article | Nouveau |
| Nom du fabricant | Isolating relay with window contact, 1 NO contact 10A |
| Marque | ELTAKO |
| Catégories |
Dispositifs de contrôle |
| Pays d’origine | CN |
| Code du système harmonisé | 8536 4900 00 |
| Tension nominale | 230 V |
| Méthode de montage | Autre |
| Fréquence | 50 Hz |
| Nombre de moteurs connectables | 1 |
| Entrée de la sous-station | No |
| Entrée centrale | Yes |
Détails d’emballage
| Niveau d’emballage 1 | 4010312205495, 4010312205495 |
| Niveau d’emballage 2 | 4010312205495 |
| Niveau d’emballage 3 | 4010312205495 |
Downloads
Description
1 NO contact not potential free 10A/250V AC. 230V LED lamps up to 100W, incandescent lamp load 2000W. With window contact. Standby loss 0.5 watt only. For installation. 45mm long, 45mm wide, 18mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Control input with internally produced low voltage 24V DC. With an isolating transformer electrically isolated from power supply and make contact (PELV). Therefore no external low voltage power supply necessary. With 2 L terminals and 2 N terminals for an easy and quick installation. Power supply 230V. The enclosed window contact consists of a Reed relay with terminals and a solenoid. The NC contact opens when the solenoid approaches closer than 25mm. The disconnection relay ETR61NP is connected to terminals T1 and T2. Power supply to the extractor only cuts in when the window is open. ETR61NP can be wired in the flush mounted socket behind the socket for the extractor. Mounting the window contact FK: Lever out the inserts at the narrow end of the housing. Wire up the Reed relay and cut out the cable entry on the housing. Affix the two housings in parallel maximum 15mm apart and also screw if necessary. In the longitudinal direction the solenoid may be twisted in any direction compared to the Reed relay.